I will start off by saying after 8 years with my husband our sex just gets better and better. I love sucking his cock, the only down side is it turns me on so much I want his cock fucking me too. Soooo he said why don't we buy a bone clone so you can have both!
Saturday night we went out and bought a Clone a Willy, we bring it home and read the directions and we both think WOW that is a lot of steps and all the while he needs to stay hard.
So the fun part begins, we sit everything out on the kitchen table ready to go for each step. Then I get down on my knees and start slowly licking his cock, with each lick I pull his cock deeper and deeper inside my mouth until I have all of him inside my mouth and can lick his balls….now he is nice and hard and I have to stop so we can start the process.
I start running the warm tap water to mix with the plaster, as I pour the warm water into the bowl I bend over the kitchen table not wearing any panties just a short dress and start to mix the plaster with the warm water. As I mix bent over the table my husband comes behind me and slowly starts rubbing his cock on my pussy and slides just the tip in and out. Now at this point we are suppose to mix for about 60 seconds. But with the distraction we forget to set the timer and we pour the mixture into the tube and slide his cock into the tube. This is where things get messy…you see we did this step too early and the mixture hadn't set enough so it was still pretty watery and spilled out everywhere. So he had to get into the shower and I cleaned up the kitchen floor.
After his shower he came back into the kitchen, at this point I was a little disappointed our first attempt didn't work but I was so incredibly hot and wet for my husband I just wanted his cock inside me.
And that night my husband made me cum twice, giving me the proper fuck I needed.
The next morning I ordered more mix online….I can't wait to try again. I just hope this time it works. But if not at least we had an amazing night trying!
Source: reddit.com/r/gonewildstories/comments/3j3a4i/clone_a_willy
This just sounds like overall fun and a good time
Oh it was!
don’t forget to tell us how the second try goes
I made one of these as well. I wish the tube was a little wider for us "bigger" guys since there are no size limitations/dimensions listed on the container. Mine’s also as crooked as a used car salesman so it didn’t sit quite right in the mixture and isn’t 100% accurate.
We have the same problem, we are going to try to find wider tube at lowes for next time.
Oh there will most defiantly be a Clone A Willy Part 2!
Rim job to help stay hard during the moulding?